- Assessment: Financial Performance Evaluation of Savory Snacks Company Ltd for Credit
- CMI L5 Assignment: Managing Stakeholder Relationships: Strategies, Challenges, and Best Practices
- Level 3 Unit 2 Assignment: Principles, Values and Regulation in the Health and Social Care Sector
- COM4006 Assignment: Introduction to Academic Skills and Professional Development
- Assessment: Managing Organisational Change: Evaluating Strategies, Challenges, and Impact
- UNIT CMI 706 Assignment: Finance for Strategic Leaders: The Role, Scope, and Impact of Finance
- ENGINEERING DESIGN TMA2 v1: CAD Design Report: Specification, Evaluation & Drawings
- Unit CMI 514 Assignment: Analysis of Organisational Change: Managing Change
- EMS402U TMA1: Engineering Design Solutions: Concept Development & Assessment
- LEVEL 3 UNIT 31: Effective Project Management (International BTEC )
- ILM Level 4 ASSIGNMENT: Managing equality and diversity in own area
- CMI 504 Assessment: The Rationale For Managing Performance Within Organisations
- Level 7 Unit 03 Assignment: Leading a Strategic Management and Leadership
- LO:01, LO:02 (MSCCO01) Managing Innovation and Change in Computing
- CMI Level 6 Certificate in Professional Management and Leadership
- Financial Accounting: Double-Entry Bookkeeping, Journals, Ledgers, and Trial Balance Preparation
- Assignment 1: Understand and Work with a Wide Range of Stakeholders and Organisational Structures
- CMI 526 Assessment: Principles of Leadership Practice
- Promoting Health, Wellbeing, and Inclusive Care in Health and Social Care Settings
- MID4022 Legal and Ethical Professional Principle in Midwifery
PROD1002: A company manufactures components with a critical dimension required to be in the range of 115mm to 116mm: Quality Engineering Assignment, UOG, UK
University | University of Greenwich (UOG) |
Subject | PROD1002: Quality Engineering |
A company manufactures components with a critical dimension required to be in the range of 115mm to 116mm.
The gauge used to measure this dimension has recently returned from calibration. In order to test whether it is capable of being used to measure this critical dimension, a Gage Repeatability and Reproducibility (R&R) study is to be carried out. The measurements of 10 sample components, each measured twice by two different operators are given below:
Use this data, along with the Gauge R&R calculator to demonstrate that this measurement system is capable of assessing the components for the required dimension.
Historically, these components have been machined in batches of 5 on a Honzaki CNC vertical milling machine. The measurements of the last 20 batches made on this machine are given in the table below:
The company has recently bought a new Kawada CNC vertical milling machine to replace the Honzaki machine. The first 10 batches of components produced on the Kawda machine are measured and the results are given in the table below:
Calculate the Cp and Cpk process capability indices for both processes (you may assume that the data are normally distributed) and comment on which, if either, the process appears to be the better suited to this task. State what improvements to the process you might recommend, and who you would expect to be responsible for such actions.
Use an appropriate Statistical Process Control chart to assess whether there is any difference in the components produced by the two machines. (hint: calculate the x-bar and r chart control limits, plot the charts, and investigate for any “out of control” conditions)
Buy Answer of This Assessment & Raise Your Grades
Achieve excellence in your PROD1002 Quality Engineering assignment with expert guidance from Diploma Assignment Help UK. Our online assignment help service is specifically tailored to meet the requirements of University of Greenwich (UOG) students. With our experienced engineering assignment help, you’ll gain a deep understanding of quality engineering principles and techniques.